Stability assessment of a tailings storage facility using a non-local constitutive model accounting for anisotropic strain-softening

Recent failures of upstream-raised tailings storage facilities (TSF) raised con-cerns on the future use of these dams. While being cost-effective, they entail higher risks than conventional dams, as stability largely relies on the strength of tailings, which are loose and normally-consolidated materials that may exhibit strain-softening during un-drained loading. Current design practice involves limit equilibrium analyses adopting a fully-softened shear strength; while being conservative, this practice neglects the work input required to start the softening process that leads to progressive failure. This paper describes the calibration and application of the NGI-ADPSoft constitutive model to evaluate the potential of static liquefaction of an upstream-raised TSF and provides an indirect measure of resilience. The constitutive model incorporates undrained shear strength anisotropy and a mesh-independent anisotropic post-peak strain softening. The calibration is performed using laboratory testing, including anisotropically-consolidated triaxial compression tests and direct simple shear tests. The peak and residual undrained shear strengths are validated by statistical interpretation of the available CPTu data. It is shown that this numerical exercise is useful to verify the robustness of the TSF design.Comment: NGI-ADPSoft, Plaxis 2D, Strain-softening, Tailings, Static Liquefactio

A cavity expansion–based solution for interpretation of CPTu data in soils under partially drained conditions

A cavity expansion–based solution is proposed in this paper for the interpretation of CPTu data under a partially drained condition. Variations of the normalized cone tip resistance, cone factor, and undrained‐drained resistance ratio are examined with different initial specific volume and overconsolidation ratio, based on the exact solutions of both undrained and drained cavity expansion in CASM, which is a unified state parameter model for clay and sand. A drainage index is proposed to represent the partially drained condition, and the critical state after expansion and stress paths of cavity expansion are therefore predicted by estimating a virtual plastic region and assuming a drainage‐index–based mapping technique. The stress paths and distributions of stresses and specific volume are investigated for different values of drainage index, which are also related to the penetration velocity with comparisons of experimental data and numerical results. The subsequent consolidation after penetration is thus predicted with the assumption of constant deviatoric stress during dissipation of the excess pore pressure. Both spherical and cylindrical consolidations are compared for dissipation around the cone tip and the probe shaft, respectively. The effects of overconsolidation ratio on the stress paths and the distributions of excess pore pressure and specific volume are then thoroughly investigated. The proposed solution and the findings would contribute to the interpretation of CPTu tests under a random drained condition, as well as the analysis of pile installation and the subsequent consolidation

Effectiveness of Color-Picking Interfaces Among Non-designers

There are relatively few studies on the effectiveness of color picking interface. This study therefore set out to measure both the efficiency in terms of task completion time and preference of four color-picking interfaces found in many design software applications including RGB, HSL, map and palette. A controlled experiment was conducted involving n = 16 participants without formal design training. The results show that the map and RGB interfaces were preferred by the participants while the palette interface resulted in the shortest task completion times. The HSL was the least favorable color picking interface for the given cohort of users. The results indicate that the palette, map and RGB color pickers found in entry level software probably are the most suitable for users without training in the use of colors.acceptedVersio

LEAP-UCD-2017 Centrifuge Test Simulation at UNINA

Within the framework of the LEAP-UCD-2017 exercise, Type B simulations of centrifuge tests were conducted assuming a hypoplastic constitutive model for sand. Differently from the most common elastoplastic approach, the hypoplasticity does not decompose the strain rate into elastic and plastic parts and does not use explicitly the notions of the yield surface and plastic potential surface. The process followed to calibrate the constitutive model is presented in detail. The initial state of stresses in the analyzed mesh, the key parameters used in the dynamic simulation phase, and a comparison of the simulation with some experimental results are reported. All the simulations were performed using the model parameters calibrated by using the laboratory test data. Finally, a sensitivity analysis of computed displacement to soil density and ground motion intensity show the influence of such factors on the seismic soil response of liquefiable soils

Friedreich ataxia patient tissues exhibit increased 5-hydroxymethylcytosine modification and decreased CTCF binding at the FXN locus

© 2013 Al-Mahdawi et al. This is an open-access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use,distribution, and reproduction in any medium, provided the original author and source are credited.This article has been made available through the Brunel Open Access Publishing Fund.Friedreich ataxia (FRDA) is caused by a homozygous GAA repeat expansion mutation within intron 1 of the FXN gene, which induces epigenetic changes and FXN gene silencing. Bisulfite sequencing studies have identified 5-methylcytosine (5 mC) DNA methylation as one of the epigenetic changes that may be involved in this process. However, analysis of samples by bisulfite sequencing is a time-consuming procedure. In addition, it has recently been shown that 5-hydroxymethylcytosine (5 hmC) is also present in mammalian DNA, and bisulfite sequencing cannot distinguish between 5 hmC and 5 mC.The research leading to these results has received funding from the European Union Seventh Framework Programme (FP7/2007-2013) under grant agreement number 242193/EFACTS (CS), the Wellcome Trust [089757] (SA) and Ataxia UK (RMP) to MAP

The State of the Art of Medical Imaging Technology: from Creation to Archive and Back

Medical imaging has learnt itself well into modern medicine and revolutionized medical industry in the last 30 years. Stemming from the discovery of X-ray by Nobel laureate Wilhelm Roentgen, radiology was born, leading to the creation of large quantities of digital images as opposed to film-based medium. While this rich supply of images provides immeasurable information that would otherwise not be possible to obtain, medical images pose great challenges in archiving them safe from corrupted, lost and misuse, retrievable from databases of huge sizes with varying forms of metadata, and reusable when new tools for data mining and new media for data storing become available. This paper provides a summative account on the creation of medical imaging tomography, the development of image archiving systems and the innovation from the existing acquired image data pools. The focus of this paper is on content-based image retrieval (CBIR), in particular, for 3D images, which is exemplified by our developed online e-learning system, MIRAGE, home to a repository of medical images with variety of domains and different dimensions. In terms of novelties, the facilities of CBIR for 3D images coupled with image annotation in a fully automatic fashion have been developed and implemented in the system, resonating with future versatile, flexible and sustainable medical image databases that can reap new innovations

Crystal sedimentation and stone formation

Mechanisms of crystal collision being the first step of aggregation (AGN) were analyzed for calcium oxalate monohydrate (COM) directly produced in urine. COM was produced by oxalate titration in urine of seven healthy men, in solutions of urinary macromolecules and in buffered distilled water (control). Crystal formation and sedimentation were followed by a spectrophotometer and analyzed by scanning electron microscopy. Viscosity of urine was measured at 37°C. From results, sedimentation rate (vS), particle diffusion (D) and incidences of collision of particles in suspension by sedimentation (IS) and by diffusion (ID) were calculated. Calculations were related to average volume and urinary transit time of renal collecting ducts (CD) and of renal pelvis. vS was in urine 0.026 ± 0.012, in UMS 0.022 ± 0.01 and in control 0.091 ± 0.02 cm min−1 (mean ± SD). For urine, a D of 9.53 ± 0.97 μm within 1 min can be calculated. At maximal crystal concentration, IS was only 0.12 and ID was 0.48 min−1 cm−3 which, even at an unrealistic permanent and maximal crystalluria, would only correspond to less than one crystal collision/week/CD, whereas to the same tubular wall being in horizontal position 1.3 crystals/min and to a renal stone 624 crystals/cm2 min could drop by sedimentation. Sedimentation to renal tubular or pelvic wall, where crystals can accumulate and meet with a tissue calcification or a stone, is probably essential for stone formation. Since vS mainly depends on particle size, reducing urinary supersaturation and crystal growth by dietary oxalate restriction seems to be an important measure to prevent aggregation

Options for sampling and stratification for national forest inventories to implement REDD+ under the UNFCCC

<p>Abstract</p> <p>Background</p> <p>Developing countries that are willing to participate in the recently adopted (16^thSession of the Conference of Parties (COP) in Cancun) mitigation mechanism of Reducing emissions from Deforestation and Forest Degradation - and the role of conservation, sustainable management of forests and enhancement of forest carbon stocks (REDD+) - will have to establish a national forest monitoring system in order to assess anthropogenic forest-related greenhouse gas emissions by sources and removals by sinks. Such a system should support the Measurement, Reporting and Verification (MRV) requirement of the United Nations Framework Convention on Climate Change (UNFCCC) as the REDD+ mechanism is results-based. A national forest inventory (NFI) is one potential key component of such an MRV system. Following the Decision adopted during the 15^thSession of the COP in Copenhagen, the most recent Intergovernmental Panel on Climate Change (IPCC) Guidance and Guidelines should be used as a basis for estimating anthropogenic forest-related greenhouse gas emissions by sources and removals by sinks and changes in forest carbon stocks and area.</p> <p>Results</p> <p>First, we present the key indispensable elements of the IPCC Guidance and Guidelines that have been developed to fulfil the UNFCCC reporting requirements. This is done in order to set the framework to develop the MRV requirement in which a NFI for REDD+ implementation could be developed. Second, within this framework, we develop and propose a novel scheme for the stratification of forest land for REDD+. Finally, we present some non-exhaustive optional elements within this framework that a country could consider to successfully operationalise and implement its REDD+ NFI.</p> <p>Conclusion</p> <p>Evidently, both the methodological guidance and political decisions on REDD+ under the UNFCCC will continue to evolve. Even so, and considering that there exists decades of experience in setting up traditional NFIs, developing a NFI that a country may use to directly support REDD+ activities under the UNFCCC represents the development of a new challenge in this field. It is therefore important that both the scientific community and national implementing agencies acquaint themselves with both the context and content of this challenge so that REDD+ mitigation actions may be implemented successfully and with environmental integrity. This paper provides important contributions to the subject through our proposal of the stratification of forest land for REDD+.</p

Options for early breast cancer follow-up in primary and secondary care : a systematic review

Background Both incidence of breast cancer and survival have increased in recent years and there is a need to review follow up strategies. This study aims to assess the evidence for benefits of follow-up in different settings for women who have had treatment for early breast cancer. Method A systematic review to identify key criteria for follow up and then address research questions. Key criteria were: 1) Risk of second breast cancer over time - incidence compared to general population. 2) Incidence and method of detection of local recurrence and second ipsi and contra-lateral breast cancer. 3) Level 1–4 evidence of the benefits of hospital or alternative setting follow-up for survival and well-being. Data sources to identify criteria were MEDLINE, EMBASE, AMED, CINAHL, PSYCHINFO, ZETOC, Health Management Information Consortium, Science Direct. For the systematic review to address research questions searches were performed using MEDLINE (2011). Studies included were population studies using cancer registry data for incidence of new cancers, cohort studies with long term follow up for recurrence and detection of new primaries and RCTs not restricted to special populations for trials of alternative follow up and lifestyle interventions. Results Women who have had breast cancer have an increased risk of a second primary breast cancer for at least 20 years compared to the general population. Mammographically detected local recurrences or those detected by women themselves gave better survival than those detected by clinical examination. Follow up in alternative settings to the specialist clinic is acceptable to women but trials are underpowered for survival. Conclusions Long term support, surveillance mammography and fast access to medical treatment at point of need may be better than hospital based surveillance limited to five years but further large, randomised controlled trials are needed

The genomes of two key bumblebee species with primitive eusocial organization

Background: The shift from solitary to social behavior is one of the major evolutionary transitions. Primitively eusocial bumblebees are uniquely placed to illuminate the evolution of highly eusocial insect societies. Bumblebees are also invaluable natural and agricultural pollinators, and there is widespread concern over recent population declines in some species. High-quality genomic data will inform key aspects of bumblebee biology, including susceptibility to implicated population viability threats. Results: We report the high quality draft genome sequences of Bombus terrestris and Bombus impatiens, two ecologically dominant bumblebees and widely utilized study species. Comparing these new genomes to those of the highly eusocial honeybee Apis mellifera and other Hymenoptera, we identify deeply conserved similarities, as well as novelties key to the biology of these organisms. Some honeybee genome features thought to underpin advanced eusociality are also present in bumblebees, indicating an earlier evolution in the bee lineage. Xenobiotic detoxification and immune genes are similarly depauperate in bumblebees and honeybees, and multiple categories of genes linked to social organization, including development and behavior, show high conservation. Key differences identified include a bias in bumblebee chemoreception towards gustation from olfaction, and striking differences in microRNAs, potentially responsible for gene regulation underlying social and other traits. Conclusions: These two bumblebee genomes provide a foundation for post-genomic research on these key pollinators and insect societies. Overall, gene repertoires suggest that the route to advanced eusociality in bees was mediated by many small changes in many genes and processes, and not by notable expansion or depauperation